PoE Power Over Ethernet 100Mbps Injector for CCTV IP Camera and Networking
To achieve best performance of a Wireless LAN, the location of Access Point (AP) must be carefully chosen. In most cases, finding a power supply for AP is a common obstacle.
Power over Ethernet (PoE) technology provides the ideal power solution to help overcome these obstacles. In Ethernet, four pairs of C5 or C5E twisted pairs are used as the medium for transmission.
The actual data transmission, however, only takes up 4-pairs of wires (pairs 1-8). PoE technology utilizes the remaining pairs (pairs 4-5 and 7-8 to conduct electricity.
This means that using this module you can power your CCTV, IP Cameras and other Networking equipment, without an external power adapter.
Ideal for outdoors, and tight spaces, where power source can't reach, but LAN wire can.
Data PIN: 1/2, 3/6
Power PIN: 4/5+ & 7/8-
Data in: Connects PC / HUB / Switch
Case of material: ABS 94V-0
Ethernet Data rate: 10/100 Mbps
Ethernet Cable: TIA/EIA 568 Cat.5/6/7
Ethernet Cable Connector: RJ-45
Operating Temperature: 0 - 40 Degree Celsius
Storage Temperature: -40 - 70 Degree Celsius
Operating Humidity: 10% to 80% RH
Storage Humidity: 5% to 90% RH
Wall Mount: Supported
Size: 50 x 55 x 25mm
1x PoE Power Over Ethernet 100Mbps Injector Spiltter for CCTV IP Camera and Networking
Note: Power adapter not included. Please use your equipment's power adapter to power the module.